Taramps HD3000 High Power Car Amplifier (2 Ohm)

Features * Number of Channels: 01 * Max. Output Power @ 13,8 VDC - 2 OHMS: 2446W RMS * Max. Output Power @ 13,8 VDC - 4 OHMS: 1403W RMS * Max. Output Power @ 12,6 VDC - 1 OHM: 3000W RMS * Max. Output Power @ 12,6 VDC - 2 OHMS: 2040W RMS * Max. Output Power @ 12,6 VDC - 4 OHMS: 1170W RMS * Input Sensitivity: 250mV @ -9,78 dBm * Total Harmonic Distortion (THD) 0,3% * Signal / Noise Ratio: >95dB * Damping Factor: 300 * Frequency Response (Full Range): 5Hz a 15KHz Crossover * H.P.F (High Pass Filter): 5Hz a 50Hz (-12dB/Octave) Variable * L.P.F (Low Pass Filter): 50Hz a 15KHz (-12dB/Octave) Variable * Bass Boost: 0 to 10dB (50Hz) * Input Impedance: 18K OHMS * Protection System: Short into Output / Power Supply High/Low * Minimum Supply Voltage: 10,5VDC * Maximum Supply Voltage: 16VDC * Idle Consumption: 1,70 Amp. * Musical Maximum Consumption @ 12,6VDC: 170 Amp. * Sinusoidal Signal Maximum Consumption @ 12,6 VDC: 340 Amp. * Dimensions (WxHxD): 229 x 65 x 288mm * Weight: 3,11Kg Precautions * Do not mount amplifier to speaker box.  Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed. * Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM). * Do not clip amplifier above 15.0v for extended periods of time * Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)