UES APS-C Sensor Cleaner:
•UES sensor cleaner is compliant with the EU REACH regulation, and the REACH Certificate of Compliance is issued by SGS.
•UES sensor cleaner is alcohol-free and ammonia-free.
•The liquid cleaner is ultrapure water-based with a resistivity of 18.2 MΩ × cm.
•It is safe for all coatings and can be used for cleaning both CMOS and CCD sensors
•It can effectively remove fingerprints, stains, smudges, and dust on any sensors without leaving a streak behind
UES APS-C Sensor Cleaning Swabs
•UES APS-C sensor cleaning swab is compatible with the camera sensor ≤ 16 mm.
•UES swab is super soft and flexible. The head of the swab is completely covered with a super fine microfiber cloth. It will not damage delicate optical surfaces.
•Every swab is produced in a class 100 cleanroom and packed in a vacuum-sealed package.
•It is easy to store and take away anywhere when you need it.
UES Superfine Microfiber Cleaning Cloth
•It is made of special ultra-micro fiber. It is soft, absorbent and lint-free. It can efficiently and effectively remove dirt, dust, fingerprints and other stains.
•It is safe to apply on any delicate optical surfaces.
•It is washable and reusable.
•Every microfiber cleaning cloth is packed in a vacuum package in a Class 100 Cleanroom.
Package Content:
•14pcs Sensor Cleaning Swabs
•15ml Sensor Cleaner
•8 pcs 15cm X 15cm microfiber cloth
Sensor Cleaning Instruction:
1.Before starting, shoot a piece of white paper with Aperture Priority (A) mode set at f/22 or higher. In the photo, you could identify where the dust is located on your sensor.
2.For DSLR reflex cameras, make sure your camera’s battery is 100% fully charged. Set camera to sensor cleaning mode, so the delicate shutter and mirror mechanisms stay out of the way, and allow you to access the sensor. This step does not apply to mirrorless cameras.
3.Use an air blower to remove loose dust from the sensor.
4.Open one end of the swab package and remove the swab.
5.Dispense 1-2 drops of cleaner to the edge of the swab.
6.Hold the handle at a 60◦ angle, off the surface of the sensor.
7.Swipe the swab from one end of the sensor to the other end with a single constant motion.
8.Turn the swab 180◦ and use the clean side of the swab to swipe the sensor in the same direction again with a single constant motion.
9.Take out an unused dry swab and reperform steps 6 to 8 above to absorb any residual cleaner.
10.Discard the used swabs and never reuse the same swab on any other sensors. Always use sealed one for other applications.
